/
CTS350-X-P / CTS175-X-P wiring detail
CTS350-X-P / CTS175-X-P wiring detail
- James Eadie
- John Marshall
Owned by James Eadie
The cabling requirements for the PoE radar sensor is shown below.
IMPORTANT: The Ethernet protective cover must always be fitted if the Ethernet cable is not in place to ensure the integrity of the unit.
For further information or to order custom length cables from Navtech Radar please contact Customer Support at: support@navtechradar.com
On this page:
For customer-assembled network connection cables, ensure that the manufacturer’s guidelines are followed - the gland part of the connector component should be tightened to 3.5Nm (30 in.lb) to create a watertight seal against the cable sheath without causing crush damage.
, multiple selections available,