2. Replacing the drive assembly
- James Eadie
In order to carry out the tasks outlined within this section, you will need to break the environmental seal of the radar sensor and expose various internal components. For this reason you need to remove the sensor from its mounting (as outlined earlier in this guide) and take it to a clean, dust free, anti-static work area.
On this page:
The CTS- series service kit contents
The kit required to service the CTS- series radar sensors is available from Navtech Radar. Please contact customer support with your radar model and serial number to obtain the correct kit.
The contents are as follows:
Drive assembly
O-ring
Plus:
Replacement battery
Self-adhesive pads
6x radome screws plus washers
Replacement breather valve
Tools & additional items you will need
3mm hex key
5mm hex key
T20 Torx® key
Torque driver for hex and Torx keys
14mm spanner (for pressure gauge)
16mm spanner
Servisol® or Silicone grease
Loctite® 243
Soft dry brush
Pressure test gauge (see image below)
Hand or foot pump with Schrader fitting
Anti-static surface and wrist strap
Latex (or equivalent) protective gloves
Pressure test gauge. Order code: NAV0128