Note that some of the links in the content below navigate away from the Industrial Automation space within the documentation system. Bookmark this link if you need an easy route to navigate back to this space.
Introduction
If you have logged in and made changes to the radar, this page explains the process of saving or discarding those changes.
Contents
Changing the Configuration
Most of the pages that can be edited have these options for saving or cancelling modifications:
Apply: This option will apply the settings to your system and will remain in use until the radar is rebooted.
Commit Changes: This option will save the changes permanently to the system.
You may need to reboot the radar for these changes to become active.
Cancel: This will cancel any changes made.
Changes Detected
If you move off a page without saving changes then a message will be displayed:
Cancel: This will return you to the screen that you were editing allowing you to save your changes.
Discard Changes: This will discard any changes that were made on the page you were editing.
Related Information
-
Vertex User Guide (Products)
-
Firmware Control and Upgrade (Products)
-
Changing the Configuration (Products)
-
Login (Products)
-
Engineer (Products)
-
User - Radar Data (Products)
-
User - Radar Hardware (Products)
-
User - Radar Configuration (Products)
-
Standard User (Products)
-
4. Using the Vertex Interface (Products)