Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Introduction

This page covers the SafeGuard™ Configuration Application Dashboard, which alerts a user to alarms caused by data exceeding threshold values quickly and easily.

It provides a live view of a connected SafeGuard™ system, which includes some raw FFT data, NavMode data and SafeGuard™ configuration.

  • To monitor the system using FFT and NavMode level data, and make adjustments using the config.

  • Quickly and easily be alerted to data exceeding threshold values in either mode.

  • An option to visually link an output alarm state change with a radar return within or without one of the defined areas. 

  • Ability to quickly identify areas that require immediate attention.

  • Provide an option to "look" at the raw radar data and see its proximity to the threshold value at each location. 

  • Allows the user access so they can identify any potential issues. 

  • The live display can be paused and can be reset to the most current view 

  • Ability to review data when required.

  • Update rate of “live” data on visualiser matches that of the sensor update rate 

  • Provides the ability to view real-time or close to real-time data.

  • The application can display raw radar data, with a minimum refresh rate of 1 Hz 

  • Allow the viewing of up-to-date raw data

  • Application is able to display radar health, this can be abstracted to a single metric

  • Provides the ability to quickly assess the health of the system and identify any issues. 

For more information about SafeGuard™ please refer to this documentation: SafeGuard™ User Guide.

Plan - this will be removed once this page has been completed.

Contents

Navigating the Configuration Application Dashboard

Space holder for a navigation guide to the Dashboard. Similar to: https://navtechradar.atlassian.net/wiki/spaces/TUN/pages/773685283/Navigating+AdvanceGuard#Main-Display-Features

The left hand side features a PPI, and the right hand side features three tabs: Settings, Navigation Data and Alarms.

PPI: Please refer to this page for more information: Configuration Application PPI

Settings: Please refer to this page for more information: Configuration Application Settings

Navigation Data: Please refer to this page for more information: Configuration Application Navigation Data

Alarms: Please refer to this page for more information: Configuration Application Alarms

Risks

  • It might not be possible to update a raw data display in real time using standard UI technology - It's possible to update the raw data display in something close to real time, but only if we scale the image size down to 65% of the original size or less. With no scaling, 1Hz is possible

  • The current plan is to display raw data at a 1Hz update rate, not the native update rate - 1Hz is still the current plan and it should be achievable. We could get 1Hz in the study, and I'm trying to achieve that in the app now

  • It might not be possible to display very large number of nav plots in real time using standard UI technology - it's possible to display either 1000 or 2000 at a time, based on a worst-case scenario where every azimuth had 5 peaks

  • A certain level of real time plots should be achievable but quantities above a certain threshold may introduce unacceptable latency. Feasibility is required to establish the maximum threshold.

Related Information

  • No labels