Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Introduction

The Radar Hardware page allows authorised operators the ability to update the hardware details of the radar. Typically this would happen if a radar has been serviced and updated.

Contents

Radar Hardware

The read-only fields are:

Model: The model name of the radar.

Lens Type: The name of the lens type used on the radar.

Orientation: The position of the radar; either normal (upright) or hanging.

Boss Angle: The boss angle is the angle of the dish or lens inside the radome. This is adjustable depending on the application.

Build Date: The date the radar was built.

Accel X: The X value of the onboard accelerometer.

Accel Y: The Y value of the onboard accelerometer.

Accel Z: The Z value of the onboard accelerometer.

Front End: The serial number of the front end.

Daughter Board: The serial number of the daughter board.

Digital Board: The serial number of the digital board.

Radar: The serial number of the radar.

SafeGuard UI: This shows if the SafeGuard UI is enabled or disabled. This is an optional feature that is subject to it’s own software licence.

PoE Fitted: If PoE (Power over Ethernet) is selected then the radar has the necessary hardware to be powered over the network connection, assuming appropriate PoE networking equipment is being used.

The options available to the Standard User are:

Service Due: A Standard User can update this field for when the next service is due.

Apply: This option will apply the settings to your system and will remain in use until the radar is rebooted.

Store Defaults: This option will store the values in an EEPROM in the radar hardware. This means that if the storage fails or if we have to change the storage, this information is always persisted and stays with the hardware.

Cancel: This will cancel any changes made.

Related Information

  • No labels