HDR300 & HDR200 - Radar Wiring Detail

Owned by James Eadie
Nov 03, 2023
2 min read

Detail below defines the wiring connection to the Radar unit.

Refer to the separate configuration sheet for network settings.

The Ethernet dust cap must always be fitted if the Ethernet cable is not in place to ensure the integrity of the unit.

  1. Pressure Valve – do not remove.

  2. Earth point – M5x10 thread – to suitable earth grounding point

  1. Binder power connector.

  1. Ethernet connector or Dust Cap.

Care point: Ensure the bayonet of each external connector is fully rotated clockwise to the locked position and the end joint onto the cable is tight to ensure a good cable seal:

Next:HDR300 & HDR200 - Factory Acceptance Test

Home:HDR300/200 - Radar Documentation