Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

Introduction



Nodes

Inputs

  • Time Link:

    • Time Frame: this defines the length of time the rule will be disabled for. After e.g. 60 seconds, the rule will  become active again.

Check

Actions

  • Rule State:

    • Enabled: select to enable a disabled rule. Leave unchecked to disable an enabled rule. 

    • Rule: select the rule to enable/disable.

    • Action: Input. 


PPI Example

In this example Disable Rule, an Area Check disables another rule. The area is the Radar Area, in blue, and the rule is the Gate Rule. Here, track 166 enters the Radar Approach Area and therefore disables the Gate Rule; a rule which controls access to the Alarm Area (in purple). Track 167 approaches the Alarm Area.

Because the Gate Rule is disabled, track 167 does not trigger an alarm by breaking a rule in the Alarm Area. 

However, the Gate Rule was only disabled for 1 minute. Therefore, nine tracks (on identical paths to 167) and 60 seconds later, the Gate Rule is enabled and track 176 now breaks the rule and triggers an alarm in the Alarm Area. 


Related information

  • No labels