To Access the Vertex Interface
To access the Vertex interface please refer to these instructions: https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/29294899/Vertex+User+Guide#Accessing-the-Radar-Interface.
The Vertex Interface
You should now see the Vertex Status page.
Please refer to https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/29294899/Vertex+User+Guide#Status-Page for more information.
Using the Log Viewer
The radar stores a record of activities in order to assist diagnostics. Due to memory restrictions, newer entries will overwrite the oldest and so the log does not retain all historical information.
https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/29294899/Vertex+User+Guide#Log-Viewer gives more information about using the Log Viewer.
Viewing Radar Data
https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/29294899/Vertex+User+Guide#Radar-Data provides information about viewing the Radar Data.
Logging in to Vertex
In order to change any radar details, you first need to login to Vertex. To do this please follow these instructions: https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/2269872475/Login#User-Login-to-Vertex.
Changing the IP Address(es)
Once you are logged in it is then possible to change System Configuration details, such as the radar sensor’s own IP address, its Subnet Mask, the Gateway IP address and/or the NTP (Network Time Protocol - where the sensor should derive its time information) address. The System Configuration details are discussed here: https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/2265514016/User+-+System+Configuration#System-Configuration.
To change these details please refer to the this documentation Changing The Configuration.
| Info |
|---|
If you changed the IP Address, you will need to use the new address to make contact once again with the sensor. |
Shipping Halt
In the unlikely event that there is an issue that cannot be resolved by following these instructions, you may need to ship the radar back to Navtech for analysis. In For this unlikely event, you should perform a Shipping Halt which will safely store any required data to the radar's SD card, and halt the radar from working.
Please refer to the Shipping Halt documentation: https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/2314993823/Firmware+Control+and+Upgrade#Shipping-Halt.
Further Vertex Information
Additional information regarding Vertex can be viewed in the Vertex User Guide.
Related information
| Filter by label (Content by label) | ||||
|---|---|---|---|---|
|