Using the Vertex interface with your CIR sensor

Owned by Katherine Lund-Yates (Unlicensed)
Last updated: Feb 02, 2022 by Charlotte Dakin-Norris
2 min read

Introduction

The CIR radar sensor has a built in web interface (known as Vertex) which provides default user level access to the radar. Vertex allows you to view various operational data (e.g. IP address, serial number, System Uptime and Radar health, etc.) as soon as it opens, however, to make any changes you will need to Login.

When first connecting, ensure there is nothing else on the network that is using the same IP address. If necessary, connect a computer directly to the Ethernet port of the radar unit and access Vertex directly in order to change the IP address (see below).

For further details:

See Connecting to a laptop or computer for details about connecting a computer locally to the radar sensor.

This page provides links to the main Vertex documentation.

On this page:

To Access the Vertex Interface

To access the Vertex interface please refer to these instructions: .

The Vertex Interface

You should now see the Vertex Status page.

Please refer to for more information.

Using the Log Viewer

The radar stores a record of activities in order to assist diagnostics. Due to memory restrictions, newer entries will overwrite the oldest and so the log does not retain all historical information.

gives more information about using the Log Viewer.

Viewing Radar Data

provides information about viewing the Radar Data.

Logging in to Vertex

In order to change any radar details, you first need to login to Vertex. To do this please follow these instructions: .

Changing the IP Address(es)

Once you are logged in it is then possible to change System Configuration details, such as the radar sensor’s own IP address, its Subnet Mask, the Gateway IP address and/or the NTP (Network Time Protocol - where the sensor should derive its time information) address. The System Configuration details are discussed here: .

To change these details please refer to the this documentation .

If you changed the IP Address, you will need to use the new address to make contact once again with the sensor.

Shipping Halt

In the unlikely event that there is an issue that cannot be resolved by following these instructions, you may need to ship the radar back to Navtech for analysis. For this you should perform a Shipping Halt which will safely store any required data to the radar's SD card, and halt the radar from working.

Please refer to the Shipping Halt documentation: .

Further Vertex Information

Additional information regarding Vertex can be viewed in the .