RAS3 - Water and Dust Ingress Protection

Owned by James Eadie
Last updated: Feb 22, 2024
1 min read

NAVTECH radars are designed to meet IP67 Ingress Protection Rating, however this protection is dependent on the way the radar is stored and installed.

Damage resulting from the Ingress of water and or dust will not be covered by our warranty if these instructions have not been adhered to.

Sealing of the RJ45 (Ethernet) connector

 The RJ45 connector on the radar unit only meets the IP67 standard when either:

a)  The Ethernet cap and its gasket are properly fitted to the base connector.

Image needed here

b)  The supplied RJ45 cable with RJ field plug shroud assembly and seal is fitted to the radar.

Image needed here

If using cables not supplied by Navtech Radar then suitable sealing shroud caps must be fitted at all times. For information or questions please contact. navtech.support@navtechradar.com

Vent Plug

Navtech radars are shipped with a breathable vent plug fitted.

Please do not remove the vent plug. The vent plug allows for differences in air pressure, particularly if we ship by air freight, and while on site during normal operation.

Image needed here

 

Replacement Cables:

Replacement ethernet, power cables and vent plugs are available from Navtech Radar Ltd.
Please contact: support@navtechradar.com

Next: RAS3 - Power cycle caution notice

Home: RAS3 - Radar Documentation