Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

  1. Remove the old rubber o-ring seal from the upper edge of the chassis and ensure that the recess in which it was sitting is clean.
  2. Wearing protective latex (or equivalent) gloves, coat a new o-ring seal with a thin layer of silicone grease and place it into the recess.
    IMPORTANT: Take care not to get any grease onto the lens/dish reflector assembly when fitting the o-ring seal. If it does, carefully remove immediately with a soft dry cloth.


On this page:

Next: 2.7 - Fit the top assembly

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.