Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2

The Terran360 software package is shipped as Ubuntu 22.04 debian package, pre-installed on an industrial fanless processing unit (Part code: ECD70A). The programme will run on start-up.

  1. The IP address for the edge computer can be found on the Radar report document enclosed within an envelope in the PeliCase. This will be in the range of 192.168.0.xx, subnet mask is set as 255.255.255.0 by default.

The IP address of a radar sensor is set at 192.168.0.1 before it is shipped from Navtech Radar. Instructions on changing this address can be found here.

  • The subnet mask of the radar sensor is set as 255.255.255.0 by default. 

  1. Configure your network switch to access both the edge computer and the radar.

  2. Connect the DC power source to the edge computer using the 19V DC power jack provided. Note, allowable power input is (15 - 36V DC), see the datasheet attached for further information.

  3. Connect the edge computer to the network via LAN2 (nearest to the DC-in port)

  • No labels