Introduction

The Static Sensor Wizard will allow you to create a rule if a target triggers a Static Sensor, it raises an alarm.

Contents

Configuring the Wizard

Choose the Static Sensor Rule type.

Select a New Static Sensor (in green) or an existing Static Sensor (in white).

Here a New Static Sensor has been selected. This will also create a New Static Sensor in the menu under Static Sensors.

Here you can configure the New Rule. Below are the default settings, and if not changed at this point they can be amended at a later date by editing the rule.

This is the resulting Static Sensor Rule: -

Nodes

Inputs

• External Input

Checks

• Static Sensor Check:

• Time Input:

Actions

• Alarm: This will sound an alarm if the Static Sensor is triggered. The Priority and Severity of the Sensor can also be configured; for example, in a highly sensitive area then you may want the highest threat level to be set.

• Camera: This will set a Camera to keep following the target after the condition clears.

PPI Example

A Static Sensor configured:

A Static Sensor triggered by a target:

• Page:
  Sections (Witness 4.0)
• Page:
  Lanes (Witness 4.0)
• Page:
  Rule Areas (Witness 4.0)
• Page:
  Alarm Areas (Witness 4.0)
• Page:
  Rule Nodes (Witness 4.0)
• Page:
  Rules (Witness 4.0)
• Page:
  Creating a Rule (Witness 4.0)
• Page:
  Rule Schedules (Witness 4.0)
• Page:
  Breach Lines (Witness 4.0)
• Page:
  Entity Timeouts (Witness 4.0)