Versions Compared

Version Old Version 4 New Version Current
Changes made by

James Eadie

James Eadie

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

In order to carry out the tasks outlined within this section, you will need to break the environmental seal of the radar sensor and expose various internal components. For this reason you need to remove the sensor from its mounting (as outlined earlier in this guide) and take it to a clean, dust free, anti-static work area.

Panel
borderColorsilver
borderWidth1

On this page:

Table of Contents
maxLevel3
indent10px

The CTS- series service kit contents

The kit required to service the CTS- series radar sensors is available from Navtech Radar. Please contact customer support with your radar model and serial number to obtain the correct kit.

The contents are as follows:

Drive assembly

Image Removed
Image Added


O-ring

Image Modified 

Plus:

  • Warranty void labels

  • Replacement battery

  • Self-adhesive pads

  • 6x radome screws plus washers

  • Replacement breather valve

Additional

Tools & additional items you will need

  • 3mm hex key

  • 5mm hex key

  • T20 Torx® key

  • Torque driver for hex and Torx keys

  • 14mm spanner (for pressure gauge)

  • 16mm spanner

  • Servisol®

 grease

  • or Silicone grease

  • Loctite® 243

  • Soft dry brush

  • Pressure test gauge (see image below)

  • Hand or foot pump with Schrader fitting

  • Anti-static surface and wrist strap

  • Latex (or equivalent) protective gloves

     Image Modified
Pressure test gauge. Order code: NAV0128


Next: 2.1 - Open the enclosure