...
Introduction
This page cover covers accessing and navigating the SafeGuard™ Configuration Application Dashboard.
Requirements & User Cases
Provide a live-time , which alerts a user to alarms caused by data exceeding threshold values quickly and easily.
It also provides a live view of a connected SafeGuard system, including raw FFT data, NavMode data, and SafeGuard config
To monitor the system using FFT and NavMode level data, and make adjustments using the config.
Quickly and easily be alerted to data exceeding threshold values in either mode.
An option to visually link an output alarm state change with a radar return within or without one of the defined areas.
Ability to quickly identify areas that require immediate attention.
Provide an option to "look" at the raw radar data and see its proximity to the threshold value at each location.
Allow the user access so they can identify any potential issues.
The live display can be paused and can be reset to most current view
Ability to review data when required.
Update rate of “live” data on visualiser matches that of the sensor update rate
Provide the ability to view real-time or close to real-time data.
The application can display raw radar data, with a minimum refresh rate of 1 Hz
Allow the viewing of up-to-date raw data
Application is able to display radar health, this can be abstracted to a single metric
Provide the ability to quickly assess the health of the system and identify any issues.
SafeGuard™ system, which includes raw radar data and SafeGuard™ configuration.
For more information about SafeGuard™ please refer to this documentation: SafeGuard™ - Collision Avoidance.
Contents
...
| Table of Contents | ||||||
|---|---|---|---|---|---|---|
|
...
Navigating the Configuration Application Dashboard
...
Have a visual viewer to show what radar data (spatially) is exceeding the SafeGuard threshold value in two modes:
Mode 1: Global mode (ignoring area offset)
Mode 2: Area based mode only showing in areas based on their offset
Analysis
Risks
It might not be possible to update a raw data display in real time using standard UI technology
The current plan is to display raw data at a 1Hz update rate, not the native update rate. Feasibility is required to ensure this is achievable.
It might not be possible to display very large number of nav plots in real time using standard UI technology
...
...
PPI Navigation Control: Please refer to this page for more information: https://navtechradar.atlassian.net/wiki/spaces/IA/pages/2543026333/PPI+Display#PPI-Navigation-Control.
PPI: Please refer to this page for more information: PPI Display.
Radar info Panel: Please refer to this page for more information: https://navtechradar.atlassian.net/wiki/spaces/IA/pages/2543026333/PPI+Display#Radar-Info-Panel.
Navigation Data Tab: Please refer to this page for more information: Radar Point Data.
Settings Tab: Please refer to this page for more information: Application Settings.
Area Alarms Panel: Please refer to this page for more information: https://navtechradar.atlassian.net/wiki/spaces/IA/pages/2543026333/PPI+Display#Area-Alarms-Panel.
Data Controls: Please refer to this page for more information: https://navtechradar.atlassian.net/wiki/spaces/IA/pages/2543026333/PPI+Display#Data-Controls.
Mouse Coordinates: Please refer to this page for more information: https://navtechradar.atlassian.net/wiki/spaces/IA/pages/2543026333/PPI+Display#Mouse-Coordinates.
Log Panel: Please refer to this section for more information: https://navtechradar.atlassian.net/wiki/spaces/IA/pages/2543026333/PPI+Display#Log-Panel.
...
Related Information
| Filter by label (Content by label) | ||||||
|---|---|---|---|---|---|---|
|