...
Enable the Config Function. Select the Areas folder in the Configuration Tree, then select New in the configuration panel.
In the configuration panel, select New Area.
This will open the New Area Wizard window. The options are as follows:
Name: Select a name that will differentiate this area from any other areas, e.g. Detection Area 001.
Type: This indicates the function of the selected Area.
General: Sets the Area as standard, non-specific area.
Detection: This Area is used to filter the detection area of the radar. This area is actually stored in the radar and is used to restrict the data being sent to only include the detection area.
Exclusion: ThisArea is also used to filter the detection area of the radar. This area is actually stored in the radar and is used to restrict the data being sent to exclude the exclusion area.
Alarm: This Area would be placed within a Detection Area, and comes with a set rule attached: any and all tracks detected within an Alarm Area automatically trigger an Alarm response.
Camera: This Area is used to restrict where camera can look, both through manual and automatic control. This ensures cameras only look where they have good line of sight and also ensures they follow any privacy restrictions.
Static Target Detection: The function of Static Target Detection Areas is to protect long-stationary targets from being absorbed into the Clutter Map.Width (m): The initial width of the Area.
Shape: A selection of different shapes theArea can take. Once an Area is added, it can be manually shaped and resized on the PPI Map Display.
Square ⃞
Rectangle ▭
Circle ◯
Once you are satisfied with your Area values, select Finish.
...