...
Creating an Exclusion Area
Enable the Config Function, then select Areas in the Configuration Tree.
In the Configuration Panel, select New, then select New Area to activate the Create New Area Wizard.
...
In the Create New Area Wizard, select Exclusion from the Type dropdown list.
...
Configure the rest of the options, and select Finish.
...
Use Standard Creating and Editing - https://navtechradar.atlassian.net/wiki/spaces/TUN/pages/206602339/Creating+and+Editing+Entities#Standard-Area-and-Shape-Manipulation to edit the shape and orientation of the Exclusion Area. Select Save.
...
The Exclusion Area will now not register any tracks that pass through it. They will be spotted again once they have left the Exclusion Area.
...
Exclusion Area Example
...
In this example
...
an Exclusion Area has been created:
A track approaches the Exclusion Area:
...
The track disappears into the Exclusion Area:
...
Once outside of the Exclusion Area, the person reappears as a new track. The original track has been lost in the Exclusion Area.
...
This Track Query illustrates the track pathways, and how they are disrupted by the Exclusion Area:
...
Creating a Partial Exclusion Area
Enable the Config Function, then select Areas in the Configuration Tree
In the Configuration Panel, select New, then select New Area to activate the Create New Area Wizard.
...
In the Create New Area Wizard, select Detection from the Type dropdown list. Configure the rest of the options, and select Finish.
...
Use the Standard Creating and Editing to edit the shape and orientation of the Partial Exclusion Area. Select Save.
...
Next, go to Radar Settings, by selecting Radar Group, and selecting Settings in the Configuration Panel.
...
Select the Tracker Settings expansion button, and then select the Channel you wish to apply the Partial Exclusion Area to.
...
Scroll down to the Tracking Areas section. Select Edit, and using the ➕ button, assign your Partial Exclusion with Partial Parameters. Select OK then Save.
...
Your Partial Exclusion Area is now assigned to the correct Tracking Parameter.
| Info |
|---|
Multiple, overlapping Areas must be listed in order of importance in the Tracking Area list. You can only order within the same parameter type and Partial parameters must be higher than normal parameters. This is because partial parameters are more restrictive than normal parameters, therefore, they have to have a higher priority otherwise they would not work. |
...
The Exclusion Areas created through a Track Query are actuallyAlarm Areas but function as Alarm Exclusion Areas - they suppress alarms within. In order to create a Track Query Exclusion Area:
Perform a Track Query, in the Playback tab, and select Show on the track results in the Query Results Panel.
...
Identify potential areas of repeated debris or unclassified tracks, then select and Locate a specific track. Selected tracks will highlight individual sightings on the PPI when selected.
...
Select Create Exclusion to insert an Alarm Exclusion Area around the track's Area Covered. The area below is outlined in orange:
...
The new Alarm Exclusion Area will appear in the Configuration Tree under the Areas folder, and can be enabled or disabled by toggling Armed/Disarmed in the Area Details Panel.
...
...
Related Information
| Filter by label (Content by label) | ||||||
|---|---|---|---|---|---|---|
|
...