...
Output Format: Select the Navigation Output Format. The Point CA-CFAR Mode output is an alternative to the standard Nav Navigation Mode output.
Nav Navigation Mode: This is the default setting. Nav mode outputs data over TCP/IP to the client. Please refer to Fore more information about Nav Points please see: https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/2261516289/TCP+Networking#Navigation-Data-Message for further information about Nav Point data.
Point Cloud:Point Cloud CA-CFAR Mode:This mode outputs data over UDP. For more information about Point Cloud data please seePlease refer to: https://navtechradar.atlassian.net/wiki/spaces/PROD/pages/2229239935/UDP+Networking#Point-Cloud-Data for more information about Point Cloud data.
IP Address: If Point Cloud has If CA-CFAR Mode has been selected as the Navigation the Output Format, then you will be able to amend the IP Addressaddress. This is used in conjunction with the the Sensor Port parameter parameter and defines the endpoint that the UDP messages are sent to.
| Info |
|---|
If the IP Address specified is a multicast address (that is, an IP address between 224.0.0.1 and 239.255.255.255) this will enable multicast sending of the Point Cloud data to that address. |
...
that address. |
Port: This field echoes the Sensor Port field shown on the FFT Data. In general we do not recommend customers change this port.
Threshold: The Threshold is the global threshold used to exclude noise and unwanted clutter. Only returns from targets that exceed this threshold will be considered for extraction. Anything below this threshold will be ignored.
...
Select the drop-down arrow in the Output Format field.
There are two options; Nav Navigation Mode and Point Cloud CA-CFAR Mode:
You can then amend any available parameters as desired and click Apply. (If you have selected Point Cloud CA-CFAR Mode there will be an additional IP Address optionand Port options.
A confirmation message will be displayed. Select Commit Changes:
A Data Applied confirmation message will be displayed:
You will then need to reboot the system for the Navigation Output Format changes to take affect:
Click Reboot:
...