Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
  1. Remove the old rubber o-ring seal from the upper edge of the chassis and ensure that the recess in which it was sitting is clean.
  2. Wearing protective latex (or equivalent) gloves, coat a new o-ring seal with a thin layer of silicone grease and place it into the recess.
    IMPORTANT: Take care not to get any grease onto the lens/dish reflector assembly when fitting the o-ring seal. If it does, carefully remove immediately with a soft dry cloth.



Panel
borderColorsilver
borderWidth1

On this page:

Table of Contents
maxLevel3
indent10px