Using SPx RadarView Lite
The SPx RadarView application consists of two files which must be located in the same folder (any folder) on your laptop:
...
- Run SPXRadarView.exe. You should see a blank main screen:
Note: In the lower panel, the Video and Turn indicators will be red indicating that there is no communication with the sensor
- Click the Channel-A menu on the toolbar, and select the Source... option.
...
- Repeat steps 5 and 6 for the other target so that you can view both on screen at the same time.
- Adjust the radar sensor level (See Section 2.7) while checking the scan graphs to ensure the best response from both targets.
- To assist with orientation, optionally click the
button to show the Graphics Control dialog box:
...
- Enable the Compass Ring option to superimpose compass graduation marks around the sensor view.
Note: North is aligned to the zero point of the radar sensor, not magnetic north.
- Enable the Range Rings option to overlay range lines every 100m onto the sensor view
Radar sensor configurations
A sample table to record data for each radar.
...
Radar Sensor
...
Serial No
...
IP Address
...
Subnet Mask
...
GPS position
Lat(N)
...
Long (E)
...
Radar Base Plate Angle (deg)
...
Example
...
100
...
192.168.1.170
...
255.255.255.0
...
59.25023
...
17.85109
...
+1.5
...
A1
...
...
...
...
...
...
...
A2
...
...
...
...
...
...
...
A3
...
...
...
...
...
...
...
A4
...
...
...
...
...
...
Outline System Diagram
Radio Frequency Energy Compliance
...
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
...
Installing in Harsh Environments
Chesterton© 740 Aerosol Application to I-Series Radar Connectors on Installation
...
Health & Safety
...
- Attach the power and data connectors to the radar. Checking their surfaces are free from dirt, oil, grease and moisture.
- If the radar has a vent plug attached temporarily cover or mask the vent so that when spraying the connectors no spray enters the vent plug.
- Evenly apply the spray to the connectors. Observing the Health and Safety guidelines while doing so.
- While drying residual product can be removed with a cloth. After drying a degreaser can be used to remove the product.
...
Next: Radar configuration record & system diagram