...
Info |
---|
The IP address |
...
of a radar sensor is set at 192.168.0.1 |
...
before it is shipped from Navtech Radar. Instructions on changing this address can be found here.
|
...
|
Changing the IP address of your laptop or computer
Open your computer's Network and Sharing Centre
...
Select the network adapter you are looking to change - in this instance the ethernet, the wired network adapter is simply named “Ethernet”.
...
Click on the “Properties” button.
...
Highlight the line “Internet Protocol Version 4 (TCP/IPv4)”, and again select properties
...
Select "Use the following IP address" and enter a suitable address. As previously mentioned, if, for instance, the sensor IP address is 192.168.0.1 and the mask is 255.255.255.0, then your computer must use an IP address in the range: 192.168.0.2 to 192.168.0.254. The computer IP address should not must be different from the radar's.
Once you have chosen an appropriate IP address, click OK to ensure this change has been saved.