Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

First, you will need to plot your carriageway. Please follow For a single carriageway you will need to plot your route against the left-hand side of the road rather than down the centre as in the image below:

...

Please continue following the guidance for drawing a carriageway covered in Adding Carriagewayshere: https://navtechradar.atlassian.net/wiki/spaces/TUN/pages/789512667/Adding+Carriageways#Drawing-a-Carriageway.

Carriageway Configuration

Once your initial carriageway is plotted, return to the Create and Draw New Carriageway window. Now you can configure the carriageway and its Rules.

  1. For a single carriageway with a right-hand and a left-hand lane, firstly ensure you deselect the Create Dual Carriageway option.

  2. Ensure you set the appropriate number of lanes for you single carriageway, in this case 2.

...

  1. This means it will be one lane in one direction and the second lane in the reverse direction.

...

  1. image-20241118-104500.pngImage Added

  2. Clear the Use Single Lane Width check box and the options for Reversed Lanes is now available for Lanes 1 and 2

...

  1. :

    image-20241118-091634.pngImage Added

  2. For left-hand traffic, select the Reversed Lanes option for lane 2. For right-hand traffic, select the Reverse Lanes option for lane 1.

...

  1. image-20241118-091829.pngImage Added

  2. Return to the PPI and ensure that the carriageway follows the route correctly. Please refer to the notes regarding plotting a carriageway Creating and Editing Entities.

  3. Complete the Create and Draw New Carriageway Wizard (information regarding the other Rules cane be found Adding Carriageways) and Save.

  4. In the example below you can see the new carriageway with two lanes; with arrows in orange showing the direction of the traffic:

...

  1. Image Added

  2. Once the carriageway has been configured, the Reverse Direction setting can be seen in the Carriageway Settings:

...

  1. image-20241118-103328.pngImage Added

  2. Each lane has its own tab, select the appropriate lane to ensure the reverse direction is correct:

...

  1. image-20241118-103524.pngImage Added

Info

Please note that when showing the lanes, the tabs use a zero-based index, therefore the first lane will 0, the second lane will be 1 and so. This has no impact on how the lane is reported in alarms. Lanes can be identified using their name or the User ID.

Video

The following video demonstrates how to create a single carriageway:

...

Related Information

Filter by label (Content by label)
showLabelsfalse
max10
cqllabel in ( "carriageway" , "configuration" ) and ancestor = "carriageway64159770"