Settings
Enabled: Select to enable Track Correlation.
Correlate Same Sensor Channels: Correlate tracks not only between sensors but internally between individual senors channels.
Speed (m/s): Sets the speed delta that will be used to compare two or more tracks which are potentially the same track from different sensors. If the speeds are within this delta then the tracks will be considered for correlation.
Direction (°): Sets the direction / course delta that will be used to compare two or more tracks which are potentially the same track from different sensors. If the directions are within this delta then the tracks will be considered for correlation.
Distance (m): Sets the distance within which two or more tracks, which are potentially the same track from different sensors, can be considered for correlation.
Period (s): Sets how often the correlation process processes tracks from all sensors. Once correlation is enabled this period will set the track update rate for the whole system.
Info |
---|
Note that the period should never be faster than the slowest updating radar being used on the site. For example, if you using a combination of 1Hz and 2Hz radar, this period should only be set to 1Hz or slower. |
Note |
---|
Please note that correlation requires very accurate alignment of the radars, with both each other and with ground truth. This will ensure accurate handover of tracks between radar and also better accuracy of the track position. |
Related information
Filter by label (Content by label) | ||||
---|---|---|---|---|
|