Page Comparison

...

1. To configure the plugin select the Edit Button:
   

   Image RemovedImage Added

2. Click the Plugin Enabled tick box:
   

   Image RemovedImage Added

3. Configure the Local and Alarm Server IP Addresses:
   

   Image RemovedImage Added

4. To add the server mapping click the ➕ button on the right-hand-side of the NVR IP Address:
   

   Image RemovedImage Added

5. Enter the NVR IP Address for the NVR:
   

   Image RemovedImage Added

6. To map the cameras to the NVR click the ➕ button on the right-hand-side of the Camera Mapping list and then the Camera drop-down to show your list of cameras:
   

   Image RemovedImage Added

7. Select the required camera and enter the camera’s IP Address or UUID, and Event ID:
   

   Image RemovedImage Added

8. You can then repeat the process to add other cameras as desired:
   

   Image RemovedImage Added

9. Click the Save button to save the configuration:
   

   Image RemovedImage Added

10. The configured server and camera mappings will be saved:
    

    Image RemovedImage Added

Configuring the IndigoVision Control Center

1. Open the IndigoVision Control Center.

2. On the Alarms Explorer panel click on the Top Site item and go to the External Systems tab:
   

   

3. Right-click on the External System panel and select New External System:
   

   

4. Enter the details for the Witness™ system and press OK:
   

   

5. If no Alarm Servers have been configured add one by right-clicking on the Top Site and selecting Add Devices:
   

   

6. If the Alarm Server is not discovered add the details:
   

   

7. Add New Zones to the alarm server if none are configured. You will require a zone and a detector for each mapped camera:
   

   

8. Right-click on the zone you wish to be triggered by a camera movement and select New Detector and ensure that the selected Activation Event Type is set to External:
   

   

9. Select the External System that was configured earlier and select the appropriate Input Number which corresponds to the Event Id you configured in the Camera User Id (please refer to https://navtechradar.atlassian.net/wiki/spaces/TUN/pages/488472654/Camera+Details#Camera-Details) within Witness™:Mapping.
   

   

10. Set the Dwell Time and click Next to review and Save the Detector:

    

11. Add an NVR to IndigoVision Control Center if one has not already been added. Right-click on the Top Site and select Add Devices:

    

12. There will be a slight delay of around 10 seconds after adding the NVR until it becomes available to use. Click on the Bookmarks tag of the NVR and the bookmarks sent from Witness™ should be visible:
    

    

...

Related Information