...
Ensure Config Function is enabled.
In the Configuration Tree, select the appropriate Radar Group folder into which you want to add the new radar.
From the Configuration Panel (by default on the right hand side of the screen), select New.
The new radar wizard will now start:
Mode: Select the mode by which you will upload your Radar Group - Basic, Auto Discover or Import File.
Layer: Select the display layer onto which you want to create the radar. See Layers for more information.
Distance Between Radars: This is the default spacing distance between radar used to automatically position the radar when you select more than 1 radar. The first radar (or only radar if creating one) will be positioned in the centre of the PPI display. The wizard assumes you have started the process with the display approximately in the correct position for the new radar. You can move the radar's position once the wizard is complete.
Model: The model of the radar you are adding. All new Witness installations should be using the CTS-350X.
Radars to Add: The total number of radars you wish to install.
Connection: The connection type and appropriate network settings.
Once each radar has been updated, select Finish.
The radars will now be created, saved to the configuration and added to the PPI display. Depending on how many have been created this may take a few seconds. Once complete, each radar can be selected, edited and re-positioned if required. In addition, all the advanced options are now available for configuration.
| Info |
|---|
Connection types: Local This means the tracking software will be running on a PC or server, managed by the Track Engine service. Typically this means the tracking software is centralised and has to make a high bandwidth connection to the radar. You only need to provide the connection details of the radar for this connection type. Note also that the servers being used in the data centre must be sufficiently powerful enough to run the required number of trackers. This connection type is also used for playing back radar data recordings where no radars or EPUs are required. Remote This means the tracking software is running is running on a remote EPU. The EPU is a small embedded single board computer which is usually located with or close to the radar. The EPU makes a high bandwidth connection to the radar but a low bandwidth connection to the rest of the software. You need to provide connection details of the EPU and the radar for this type of connection. On-Board This means the tracking software is running on the radar sensor itself. This feature is only available with the CTS-350X version 4.0 and newer. In this setup the high bandwidth connection is inside the radar and the only a low bandwidth connection is used to link to the rest of the system. You only need to provide the connection details of the radar for this connection type. |
...
Select the appropriate Radar Group and select the Settings button. This will open the Radar Group dialog:
Select the appropriate radar from the list and select the Edit button to make changes. See Radar Settings for more information.
Once complete, select Save. If you wish to undo your changes, select Cancel.
...
Select the radar group and click Settings:
The radar group dialog will open:
Highlighting several radars will allow you to edit certain settings of these radar together. See Radar Settings for more information regarding these options.
When the Update Debris option is selected then the options applicable to the debris channel along with options common to all channels will become available to edit. And when applied they will only apply to the debris channels on the selected radar. If you don't select the debris channel then all the changes, where relevant, will apply to all the non-debris channels on the selected radar.
To select a value to change, you must first select the relevant Apply checkbox. This will enable the field. Only values where apply has been selected will be updated on the selected radar:
| Info |
|---|
When selecting multiple radar the dialog is automatically put into Edit mode. |
...