...
Multicast Interface Address (Required for Management Server, Camera Controller, Mobile Server & Track Engine Installs): This field can be left at the default 0.0.0.0 where there is only one network adaptor in the system and where that adaptor is only configured with a single IP address. If the system has multiple adaptors or a single adaptor with multiple addresses (a setup usually referred to as multi-homing) then this field must be set to the IP address used on the interface which connects the system to the rest of the Witness™ services.
Multicast Address: The multicast address has two modes of working,1 - hen using .
One method uses failover in multicast mode, this is which has a multicast address of the form 239.x.x.xThen using .
The other method uses failover in unicast mode this which is a pair of addresses of separated by a comma for the Management serversServers, with the first address being the MS Management Server you are installing the MS ontoManagement Server onto. For example, you have two Management Servers - MS1 with an IP address of 192.168.0.5 and MS2 with an IP address of 192.168.0.6. So, when installing onto MS1, the address would be 192.168.0.5,192.168.0.6 and when installing on MS2 the address would be 192.168.0.6,192.168.0.5.Management Server Rank (Required for Management Server Installs Only): This field must be completed when you are installing more than one Management Server. The rank dictates which of the two servers is primary and which is secondary. A lower rank value (normally 0) indicates the primary server. A higher value (normally 1) indicates the secondary. If you are not using the resilient features, then this field should be left at the default value of 0.
Database Server Address (Required for Management Server Only): This is the address of one or more of the database servers that the Management Server is required to use. If you are using a single database, then should be the IP address of the database system. If you are using a replica set - for resilience - then typically you will need to provide three IP addresses, one for each server in the replica set. The IP addresses can be entered as a comma separated list i.e., 10.0.1.10,10.0.1.11,10.0.1.12
Database Name (Required for Management Server Installs Only): This must be completed with the name of the database used for this installation. Unless you have a specific requirement to change the name it should be left at the default value.
...