Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Factory settings

  • The IP address (e.g. 192.168.0.1) of the radar sensor is preset before leaving Navtech Radar. Instructions on changing this address can be found here.

  • The subnet mask of the radar sensor is often preset to 255.255.255.0 by default. 

  • If the sensor IP address is 192.168.0.1 and the mask is 255.255.255.0, then a directly connected computer must use an IP address in the range: 192.168.0.2 to 192.168.0.254.

Changing the IP address of your laptop or computer

  • Open your computer's Network and Sharing Centre 

...

  • Select the network you are looking to change - in this instance the ethernet. 

...

  • Click on Properties

...

  • Highlight the Internet Protocol, and again select properties

...

  • Select "Use the following IP address" and enter a suitable address. As previously mentioned, if, for instance, the sensor IP address is 192.168.0.1 and the mask is 255.255.255.0, then your computer must use an IP address in the range: 192.168.0.2 to 192.168.0.254. The IP address should not be different from the radar's.

  • Once you have chosen an appropriate IP address, click OK to ensure this change has been saved.