...
| Table of Contents | ||||||
|---|---|---|---|---|---|---|
|
...
Settings
...
Enabled: Select to enable Track Correlation.
Correlate Same Sensor Channels: Correlate tracks not only between sensors but internally between individual sensor channels.
Speed (m/s): Sets the speed delta that will be used to compare two or more tracks which are potentially the same track from different sensors. If the speeds are within this delta then the tracks will be considered for correlation.
Direction (°): Sets the direction / course delta that will be used to compare two or more tracks which are potentially the same track from different sensors. If the directions are within this delta then the tracks will be considered for correlation.
Distance (m): Sets the distance within which two or more tracks, which are potentially the same track from different sensors, can be considered for correlation.
Period (s): Sets how often the correlation process processes tracks from all sensors. Once correlation is enabled this period will set the track update rate for the whole system.
| Info |
|---|
Note that the period should be slightly slower than the slowest rotating radar on the site. For example, if you using a combination of 1Hz and 2Hz radar, this period should only be set to a value of 1.2 seconds or slower. If the site only had 2Hz radar then you would set the period to 0.6 second or slower. |
Track Expiry Factor: This is a factor to apply to stop tracks expiring whilst still being updated.
...
Related Information
| Filter by label (Content by label) | ||||
|---|---|---|---|---|
|
...